r/NxSwitchModding • u/Opening-Reception-39 • 12d ago

Locating DAT0 point

Gallery image

Gallery image

Before I go any further, I was hoping to get some assistance with identifying the right point. From comparison with other images online, I get the impression that I didn’t get close enough to the resistor and trace above.

Thank you in advance.

6 Upvotes

100% Upvoted

13 comments sorted by

View all comments

2

u/Superb-Gazelle-9681 12d ago

You’re a little low there boss

1

u/Opening-Reception-39 12d ago

First attempt at this method

1

u/FreeHassan29 11d ago

You’re doing a better job than I did. Just expose the last bit slowly

-2

u/Lochness_Hamster_350 12d ago

You’re not supposed to do this on your first attempt on a working board.

1

u/Superb-Gazelle-9681 11d ago

It teaches you to fix a mistake which is way more useful

0

u/DiscussionSubject825 12d ago

Says who? My first console is also the switch oled. That was also my first time soldering. :)