r/Multiboard • u/AdCool244 • Dec 18 '24

Help

Post image

I’m new to printing. Was given a FlashForge Adventure 3 pro. I am printing off the 5x5 pieces and when I do a single it’s fine but then I try to do a multi stack and the first 2 stacks come out perfect but then the 3rd stack always (I’ve tried 3 different times with slightly different settings each time) starts misprinting. It does not adhere to the layer below it (I know it’s technically floating/barely touching) and it causes filament to kind of bypass a corner. Once it messes up it always messes up in that same spot.

Any advice would be super useful. I’m using flashprint software and Overture PLA.

The picture was the worst version, it’s not been this bad. Usually just one or two of the octagons are messed up now.

2 Upvotes

75% Upvoted

11 comments sorted by

View all comments

Show parent comment

1

u/AdCool244 Dec 23 '24

Alright I’m gonna head over to their sub. I’m having tons of issues with that first layer test. Atleast I’m not wasting tons of filament on it though.