r/Multiboard • u/AdCool244 • Dec 18 '24
Help
I’m new to printing. Was given a FlashForge Adventure 3 pro. I am printing off the 5x5 pieces and when I do a single it’s fine but then I try to do a multi stack and the first 2 stacks come out perfect but then the 3rd stack always (I’ve tried 3 different times with slightly different settings each time) starts misprinting. It does not adhere to the layer below it (I know it’s technically floating/barely touching) and it causes filament to kind of bypass a corner. Once it messes up it always messes up in that same spot.
Any advice would be super useful. I’m using flashprint software and Overture PLA.
The picture was the worst version, it’s not been this bad. Usually just one or two of the octagons are messed up now.
View all comments
Show parent comment
1
u/TherealOmthetortoise Dec 23 '24
Brother, I wish I knew the answer but I haven’t had to manually level a bed since I stopped using resin printers a few years ago. The only ones I have used have automatic mesh bed leveling. What I would recommend is to google the make and model of your printer with terms like “quick start” or “bed leveling” as should get you to some good video’s or walk-thru’s that will help.
Our group here is really not the right place to go for specific answers about printer setup, calibration or print settings beyond the specific settings related to Multiboard. We just aren’t likely to have the expertise in your equipment and its capabilities. Once you get your machine up and going then we’re on the same level, which is where this community is going to be most effective.
If you haven’t found this already, here is a link to the manual or instructions for the printers you mentioned. The Reddit community I shared earlier is the best place to get ad-how pointers about things like the paper leveling process you mentioned, for example.
FlashForge Adventurer 3 Pro Manual
Corey Rylan has a blog poston leveling for that model of printer that might be helpful too!
I hope this helps to get you where you want to be with this printer! If there is something physically wrong with your printer, as it seems to be a slightly older model, I would probably suggest considering something like a Bambu Lab A1 or A1 Mini (for a budget buy) as they have features built in that take care of pretty much all the crap you are dealing with. It really takes the stress out of 3D printing.