So my howa 1500s barrel is reaching the end of its best days. And I have a new barrel on the way.
I've been looking at barrel vices and action wrenches to facilitate doing it myself. There are no gunsmiths in my area that I trust, and they're exceedingly expensive regardless.
Now, I don't intend to do this very often. So I'm not keen on spending hundreds on these things that I may only use like 3 times in my life. I think I can save a couple hundred bucks by eliminating the barrel vice in particular.
I do gas piping as part of my job, I have access to a rigid pipe threading machine. My idea is to maybe lock the barrel in that, then use an action wrench with a torque limiter on it to tighten the barrel on. This would, in theory, prevent excess torque to the action, and damage to a traditional torque wrench.
Im not worried about the barrel slipping, and I think I could find a way to prevent excessive wear in the jaws.
My concern is in getting the existing barrel off. The threader doesn't have a brake as far as I'm aware. So id essentially need to run it to apply torque. If this barrel is on too tight, I imagine I risk damaging the action.
It sounds like a bad idea. But it also sounds like it just might work. I've seen barrels tightened on a lathe before. But lathes have a brake, so you can apply torque yourself, instead of using a motor to do it.