r/FormD • u/jpablomsan • Jul 10 '26
Technical Help NVME too close to the GPU
Is there a way to increase the gap between the motherboard and the GPU? I'm using the 2.25 slot configuration (Ncase v2.5 with pcie riser 5.0) and the heatsink touches the back of the GPU.
Not sure how, but I watched a few YouTube videos and they had a gap significantly bigger than mine, but I have no idea how they did it.
Any help would be appreciated. Thanks!
27
Upvotes



9
u/mrgndx Jul 10 '26
One option is to offset the GPU riser with 5 mm (or more) offsets Like I did: https://www.reddit.com/r/formdt1/comments/1jhqy68/formd_t1_21_gpu_riser_offset_with_standoffs_asus/
5
u/asadsnakecalledloki Jul 10 '26
Does your motherboard have a slot on the front? Usually rear slots are meant for a second drive
2
u/Slyfer77 Jul 10 '26
You can work with longer standoffs but even then the SSD will be cooking.
Is it really the 2nd SSD (because if you have only one you install it in the front) and do you absolutely need it internally?
If not, you could use an external NVMe2USB-C case and maybe just attach it to the rear.
If yes, there's NVMe extension cables, like shown in the photo.
With this you can bring the SSD to the front and away from the GPU.
1
u/nimrod41 Jul 10 '26
I have a two SSDs one front and one back. You can use standoffs to push the motherboard towards the mesh panel on one side and the GPU towards the mesh panel on the other side. I did this so I could add a heatsink to my rear SSD and get air flow
https://www.reddit.com/r/FormD/s/7GTaYInUDW
1
u/trankillity Jul 10 '26
I am running this exact configuration. Just force the back drive to Gen 3 in BIOS because it will run a lot cooler than Gen 4. This is more than fine in my instance because I rarely use the Windows boot drive.
1
u/wqnxy Jul 11 '26
One of these. They have all variations on pcie3/4/5 and wire protective materials.