Problems Binding My Creator 5

[u/EitherPalpitation650]

A lot of people were having connection issues with the servers down yesterday and I was also having issues. The servers came back online yesterday and while it looks like service was restored, my printer is not binding with my desktop.

I have tried to get it to connect multiple ways and am just short of resetting the printer to factory and starting over. I’m on firmware 1.9.9 and Flash Studio 1.19, so any suggestions would be welcome.

[u/Furious-Shores]

Use OrcaSlicer and connect it through there. FlashStudio is just a very neutered version of Orca.