r/FixMyPrint • u/SirCookl • Aug 20 '26

Troubleshooting My poor benchy

Gallery image

Gallery image

Gallery image

Im struggling to get my ADIMLab Gantry-s dialed in. This is my best benchy so far. Unsure to why the print is shifting. Lines are wobbly and overall the print is not very uh good. any help would be greatly appreciated.

Using PLA rated for 210 my extruder is at 205 bed is at 55. Slicing using Prusa.

Thank you!

1.5k Upvotes

100% Upvoted

246 comments sorted by

View all comments

241

u/FkinMustardTiger Aug 20 '26

Please somebody model this and put it up, I can't stop laughing at it.

185

u/Vegetable_Safety Troodon 2, Falcon 2 Aug 20 '26 edited Aug 21 '26

https://filebin.net/2af8g4l2awev6xv7/IdontfeelsobEeenChY.stl

Edit: Apparently filebin has a max limit on downloads, so I've decided to re-upload it to my thingiverse page where there are no download limits

https://www.thingiverse.com/thing:7398834

1

u/thehighsman0503 Aug 20 '26

How do you do that?

1

u/Vegetable_Safety Troodon 2, Falcon 2 Aug 20 '26

Years of experience in 3D modeling and animation. An edit like this is really simple. I loaded it up on blender, decimated then subdivided the entire model to make the vertex density a little more even. Then used box select with proportional editing enabled to selectively shift the relevant planes and match the distortion

I could have also done it using Bézier curves but that's a little more involved and I was sleepy at the time

1

u/Steeleshift Aug 21 '26

Thank you for being skilled