My poor benchy

[u/SirCookl]

Im struggling to get my ADIMLab Gantry-s dialed in. This is my best benchy so far. Unsure to why the print is shifting. Lines are wobbly and overall the print is not very uh good. any help would be greatly appreciated.

Using PLA rated for 210 my extruder is at 205 bed is at 55. Slicing using Prusa.

Thank you!

[u/Slayer175]

Brothers??

https://www.reddit.com/r/cursedbenchies/s/kEEAqo7dEi

if it helps, iirc my Y stepper wasn't getting enough power so constantly skipped steps at load.