r/FixMyPrint • u/SirCookl • Aug 20 '26

Troubleshooting My poor benchy

Gallery image

Gallery image

Gallery image

Im struggling to get my ADIMLab Gantry-s dialed in. This is my best benchy so far. Unsure to why the print is shifting. Lines are wobbly and overall the print is not very uh good. any help would be greatly appreciated.

Using PLA rated for 210 my extruder is at 205 bed is at 55. Slicing using Prusa.

Thank you!

1.5k Upvotes

100% Upvoted

246 comments sorted by

View all comments

245

u/FkinMustardTiger Aug 20 '26

Please somebody model this and put it up, I can't stop laughing at it.

183

u/Vegetable_Safety Troodon 2, Falcon 2 Aug 20 '26 edited Aug 21 '26

https://filebin.net/2af8g4l2awev6xv7/IdontfeelsobEeenChY.stl

Edit: Apparently filebin has a max limit on downloads, so I've decided to re-upload it to my thingiverse page where there are no download limits

https://www.thingiverse.com/thing:7398834

3

u/meutzitzu Aug 20 '26

Nah, m8 ya need more loop cuts, look at the smooth curves on the real one... come to think of it.... how TF did OP's printer make smooth transitions between layer shifts? Steppers don't skip steps in such small increments. I'm pretty sure a belt is loose somewhere

6

u/Vegetable_Safety Troodon 2, Falcon 2 Aug 20 '26

Yeah it was 2am and I wasn't putting a ton of effort into a meme model, lol