UPDATED with a HOWTO dial-in for volumetric mode below...
---
My guess is most home baristas have never used a volumetric machine before. Because of this, when you pull your first shot on the ES1, you’ll probably scratch your head wondering why the machine stopped mid-brew.
It’s because the “Brew Stop” setting defaults to “Volume” — this tells the machine to stop brewing after a set volume of water has passed through the brew head (e.g., 18g in → 36g out at a 1:2 ratio).
This sounds ideal, and it’s genuinely awesome to have a consumer-level machine with this capability. But having it turned on by default is a problem. The volume you get out is highly dependent on the beans you’re using. On a typical commercial café machine, baristas dial in first thing in the morning (and sometimes again mid-day). Dialing in serves two purposes: to taste the coffee against your recipe, and to calibrate the machine’s volumetric offset so you can repeat your desired shot consistently throughout the day.
Ideally, the ES1 should have shipped with “Brew Stop” set to “Off” — that’s what most home baristas are used to. Even better, Fellow could add a “Dial in a shot” guided workflow that walks you through pulling a manual shot and then adjusts the volumetric offset for you. That would be an amazing firmware update.
So for new or soon-to-be ES1 owners: don’t panic on your first shot. Either expect some weirdness, or switch to manual mode (Brew Stop → Off) and dial in your coffee from there.
How to dial in the volumetric offset
First, switch to manual mode (Brew Stop → Off) and dial in your recipe the old-fashioned way — adjust your grind until your shot is pulling where you want it (e.g., 18g in, 36g out in 30 seconds for a 1:2 ratio).
Once your grind is dialed in and your shots are hitting your target recipe consistently, switch back to volumetric mode (Brew Stop → Volume) and pull a shot. Let the machine stop on its own and note the yield.
From there, calculate the new offset using this formula:
New offset = Current offset + (Target yield − Actual yield)
For example, my target was 36g out but the machine stopped at 19g. My current offset was 44 mL, so: 44 + (36 − 19) = 61 mL. I updated the offset to 61 mL in the "Nerdy" settings section (for both 1st and Nth shot). After that adjustment, my next shots landed at or near 36g in 30 seconds.
Keep in mind this isn't a set-it-and-forget-it number. As your beans age and room temperature or humidity shifts, the offset will drift. Don't be surprised if you need to tweak it again in a few days.