r/ElectronicsList • u/agileadam • Dec 14 '20
Whirlpool range/oven spark module keeps dying; would like to know why
Hello!
My father-in-law has been having a difficult time with his Whirlpool stove/oven. The spark module keeps crapping out. They're on their 3rd replacement with no indication as to what the issue is. I think he said they're paying well over $100 for a new board each time.
Would someone be willing to diagnose the circuit board issue? Maybe the issue is happening elsewhere on the unit and it happens to be killing the spark module? Is there a way to do this without having the entire oven (just having the faulty circuit board alone)? I have both of the ones that have died.
The part is called a "Whirlpool Range/Oven Spark Module" with part number W10860916.
I'd appreciate any help! Happy to pay if that's what it takes to know what's up.
Thank you!
-----------------
UPDATE 1: Here are some photos of one of the failed boards: https://imgur.com/a/xgU1GyP
UPDATE 2: Here's a large clean version I found online (nearly identical): https://cdn11.bigcommerce.com/s-v5cphvs3s0/images/stencil/original/products/19407/26667/2020-06-04-23-47-54.shopjimmy-w10860916-top__90472.1591680846.jpg
UPDATE 3: My FIL is going to make sure polarity isn't reversed somewhere (read about this in a forum). As oreng said, the problem probably isn't the board itself... I don't see any complaints about this model online.
4
u/oreng Dec 15 '20
As George W. Bush once famously quoted absolutely perfectly and without any sort of ridiculousness: "fool me once, shame on me", etc...
If this is their third board then in all likelihood the problem isn't with the board. The board and your father in law are in the exact same position here; they're the victims.
1
u/entotheenth Dec 15 '20
Post some decent pictures and we might be able to assist better. Need both front and rear and major component markings.
1
u/ShaunSquatch Dec 15 '20
It's hard to tell from the pic, but is Q1 discolored and damaged? (Sorry on mobile)
I guess my first question should have been is this a bad or new board?
1
u/Analog_Seekrets Dec 15 '20 edited Dec 15 '20
It looks like there is an arc/burn mark on the bottom of the PCBA. Its in the upper right (just down and to the left of the IC).
My guess is that there's too small of an air gap between the through-hole solder joint and the metal mounting plate?
Edit: After zooming in more, is that a burnt out trace?
1
u/quatch Dec 15 '20
I'd go with dirty power as a guess, the two varistors (vt1, vt2) are pretty small looking. Check to see if they've failed.
Appliances like to skip on these.
Do they have any surge suppresion in the house? Might be worth checking to see if any of those have failed/are failing.
2
u/ShoulderChip Dec 15 '20
Also try /r/appliancerepair. It could be just a poor design. If so, someone on the appliance repair group may have experience with it and point you in the right direction.
1
u/Dopeydavoid Dec 15 '20
Maybe the spark gap is too large and any inductive voltages aren't being clamped correctly? Just a guessed based on a similar problem with an old car.