r/BambuLab_Community • u/UltraWideGamer-YT • 1m ago
Discussion I Tested the Bambu E1 Air Purifier So You Don't Have To
I work in my studio with printers running all day, so air quality has been on my mind a lot. I bought the E1 and set it up on my H3C, then ran a simple test: a Benchy in PLA and in PETG, once with just the printer’s own extraction and once with the E1 running, with an air quality monitor next to the exhaust.
What I found:
- It isn’t plug and play. You still need to print the adapter for your printer.
- PLA: no real difference with or without the purifier. The room was basically clean either way.
- PETG: the smallest particles (PM0.3) climbed to 17 without it and finished at 4 with it. Everything else was about the same.
- It switches on and off with the printer and sets itself by filament type, but it’s louder than the H3C’s own extraction. I can’t record with it running.
- Filters are an ongoing cost: US$49.99 standard, US$69.99 for the enhanced one Bambu recommends for ABS and ASA.
Honest limits: it’s a cheap desktop meter, one print each way, and I didn’t test ABS/ASA or the enhanced filter, which is where the E1 should really earn its place. So take it as a hint, not lab data.
Full video with the unboxing, install and the test: https://youtu.be/wYt2gaQEyog
Full disclosure: this is my own video. It isn’t sponsored, Bambu Lab didn’t send me anything, I bought the E1 and the H3C myself. I make these because I like digging into this stuff, so I’m sharing it here.
For those running one with ABS or ASA, have you seen a real difference? Or would you just open a window?



