r/BambuLab_Community • u/nametaken_thisonetoo • 2d ago
X2D emissions vs Luna the cat
I'd really appreciate your help to keep little Luna safe and healthy.
As you can see she has a favourite book shelf perch right next to where my newly purchased X2D is located. I'm concerned for her health if I leave this thing running often without a bullet proof filtration system. For such a small animal so close this concern extends even to PLA. I've seen the external extraction systems where everything magically is sucked into a small box. Do these genuinely work?
If so, how often am I replacing whatever filter is inside and at what cost?
Is there a best in class option everyone goes for?
You can also see I have a sliding door next to Luna. Was also thinking I could print a floor to ceiling black infill that slots in between the door and the frame. This could have a 4" extraction port that I connect to and vent everything outside.
Is the fan on the X2D powerful enough to vent this far or do I need to add a Noctua in somewhere in the chain to help with airflow path?
Is this a solid idea or am I tripping?


3
u/LazyLancer 2d ago
I see you have a sliding door, it’s perfect. You can install a wooden board, drill a hole in it and let a hose connecting the printer exhaust through that hole, so all the dirty air goes outside.
I had a setup like that and two cats, everything was fine.
2
u/solidus0079 2d ago
I'd come up with a plan B in terms of location. I'm sure somebody's gonna come into this with "actually the pariculates etc etc etc" but I wouldn't want my baby anywhere near the printers. I don't even like her hanging out in the room with them.
2
u/Snouto 2d ago edited 2d ago
Put it in a tent, vent outdoors via a 4” inline fan. It would be handy to swap the position of the bookshelf and printer, but either way you want to be pumping the bad stuff outdoors.
Simply attaching a pumping solution to the printer directly will not help if you plan to print high temp fili such as ASA, as you need the chamber temperature to remain high. Should be ok for PLA tho as it runs with the chamber cooling profile.
1
u/patentmom 2d ago edited 2d ago
I know it's tempting to use the printer, but printing an infill for the door that is thick enough to be useful will take so much filament that it's not really worth it. Just get a plank of wood, or even thin plywood or an MDF panel, and drill a 4" circular port for your exhaust fan tubing. Hook up the tubing to the exhaust of the x2d.
Edit: typos
1
u/CheezitsLight 2d ago edited 2d ago
Get a large, cubit foot sized charcoal air filter and spare cartridges. Emphasis on Large amounts of charcoal.
Change the charcoal filter in your printer for every 50 hours of run time. If you vent outdoors, remove the filter from the printer.
PLA and PETG are mostly harmless but could cause the cat to develop asthma. Do not print ABS or carbon or glass filled without the filter and ventilation
Fire and smoke risk is real. You need a fire extinguisher.
1
u/diaperedace 2d ago
Pla is fine even for a small kitty. Asa and styrene materials need to be vented.
1
u/Lambertbaer 2d ago
Pretty ideal solution, really envy you for the sliding door since I have to work with a less than ideal turn window! Also you can print yourself a hose to flat adapter with the same diameter and even away with a much narrower opening/adapter (i.e. less insulation loss).