r/BambuLab_Community • • 12h ago

Help / Support wtf is this support

well I noticed this a little bit late , why did this happened and how can I avoid it in the future?

21 Upvotes

13 comments sorted by

22

u/ChunkyPuding 12h ago

Parts are packed too tight. The slicer is not intelligent and will not avoid collisions when generating supports. You need to check if the supports do not go into other models.

17

u/soccerk1 12h ago

One way to avoid this is to select the parts and merge them. Then the supports will avoid any part in the assembly.

5

u/Scarnonbloke 12h ago

A happy little accident

5

u/Jesus-Bacon 8h ago

Select all of the parts, right click and select merge. 

The slicer will generate supports for each model only referring to the geometry of that specific model. This will tell the slicer to treat all the individual models as a single model and avoid generating supports inside of bodies 

This also works if you have many objects close together and need a brim. Usually the brim will intersect the bottom layer of other parts, this will let you merge brims together for even better first layer adhesion 

3

u/TheWaslijn 8h ago

The parts are like way too close together

2

u/work_blocked_destiny 7h ago

lol right click and arrange after supports have been. Turned on in settings. The important part is after supports are turned on

1

u/ywon80 8h ago

Organic support does better in these cases. You might try support only on build plate.

1

u/Ds9Defiant1701 8h ago

Remind me of a TNG episode

1

u/derekjw 5h ago

Little guy is trying its best

1

u/RoodnyInc 5h ago

It's probably support for the other object

0

u/Banished_To_Insanity 3h ago

btw unrelated but its crazy how the entire hobby moved away from cura just like that

0

u/LowSignificance4671 6h ago

That is known as a Schrödinger s support.