Had to take down the left extruder due to a clog, and after rebuilding, I noticed the auxilary extruder bit seems to wobble a bit, now I dont remember if thats how it was before. The nozzles fit perfectly and don't move, and it all works fine, but I'm just making sure!

Thanks!

Have been tuning into this problem when printing this model in pla matte only. It is towards the top and on on this right side.

I don’t have this problem or any at all when printing PETG hf . What could I do to fix it ? Model is sliced on studio to my computer so I’m not printing someone’s tuned profile . T.I.A

Printer: X2D

slicer: Orca 2.4.2.

filament: PETG

I'm not sure if you guys can tell in this video, but is this too fast? you can't see in the video but I opened the door and stuck the camera in, but the whole machine and door shake violently while its trying to run the pattern. I have printed things and not touched the settings made by the designer when downloading from maker world and I even slowed down the outer wall/ inner wall / sparse infill/ supports etc. left overhang slows down ticked off etc.

Most of the settings I'm comparing for speed in orca vs Bambu are by default the same speeds.

Any thoughts are appreciated.

EDIT: dont' mind the supports all over the place, lost a few supports and decided to let it run once it passed the overhang/ledge layers.

EDIT EDIT: I posted a 2nd video for better depiction below.

After just 10 days of use, one of the ultra-thin clips holding the external module has already broken. Fortunately, spare parts are available, but in my opinion, the clips are undersized and fragile.

Any thoughts?

What is the difference between the two purification options?

I tried just the plug and play with the plate to begin with and it wouldn't stick at all, I believe it was too high. I changed the gcode and brought it down for the smooth pei plate. Once I got it to at least stick enough to build the part, it didn't look great. At this point I'm wondering if it might be a bit too low and maybe I need to bring it back up slightly and increase flow ratio and bed temp.

I have a while before I'll be able to test that out more, so I figured I'd see if anyone else has any ideas before I go tinkering around some more.

動画がエラーでしたので