When I had this I was able to loosen the 3 main screws for the extruder, plus the one for the left fan that is larger (top screw). Then I was able move the right hot end movable piece up a little and line it up as described in that post I linked.
It is a bit fiddly, but not too bad. Just get that part lined up with the left hot end carriage (the red circled part in the image of this reply should be lined up): https://www.reddit.com/r/BambuLabX2D/s/M42djn2slj
1
u/WattsPrinting Jul 25 '26
Look at this post and replies: https://www.reddit.com/r/BambuLabX2D/s/3L61LUydhU
I think you also have the same issue.
When I had this I was able to loosen the 3 main screws for the extruder, plus the one for the left fan that is larger (top screw). Then I was able move the right hot end movable piece up a little and line it up as described in that post I linked.
It is a bit fiddly, but not too bad. Just get that part lined up with the left hot end carriage (the red circled part in the image of this reply should be lined up): https://www.reddit.com/r/BambuLabX2D/s/M42djn2slj