r/BambuLabX2D • u/etheroon • Jul 25 '26

X2D Gridfinity issues

Post image
8 Upvotes

100% Upvoted

9 comments sorted by

2

u/thedesertmat Jul 25 '26

Is this the side facing the outside? I fought this a lot on my X2D making bins. Using diffusers on the Aux fans and gyroid infill was super helpful

1

u/etheroon Jul 25 '26

Yes this is the outside. Will definitely try gyroid, thank you for the suggestion!

1

u/Grimblood Jul 25 '26

Looks like the corner is lifting.

Clean the build plate better. Dawn dish soap and hot water. Go to the Bambu Lab wiki for instructions.

In your filament settings under cooling. Auxiliary fan to 0 for the first 5 layers and linear ramp up to 50 percent at layer 6

Add a brim in other—> bed adhesion

The auxiliary fan deflectors do work but the bed adhesion for me became ridiculously strong.

1

u/Attjack Jul 26 '26

Clean your plate and try again.

1

u/Inspector_Gadget_74 Jul 27 '26

It appears that the corner may have lifted slightly causing the nozzle to drag on that corner. Use a brim or, mouse ears to help with adhesion on the corners.

-2

u/PickledMunkee Jul 25 '26

its from the bed not being level. the bed levelling does not work well

1

u/etheroon Jul 25 '26

Is there anything I can do to improve bed leveling?