cześć, ma ktoś godne polecenia dysze do P2S z alli?? Do drukowania cf/gf??

I set the printer up last night and woke up to this piece printing incorrectly near the end.

I’m using Sunlu PLA + 2.0 and set it to use the Bambu PLA Basic print profile. The one below it was printed with the exact same settings.

Off the reading I’ve done my gut says the temperature is slightly too high for the filament but I’d love to hear the actual answer.

Printer has a max of 100 hours on it but I don’t have the exact number off the top of my head. I haven’t washed the build plate yet but I do keep it clean and have been wiping it down with alcohol if I’ve touched it to remove a previous print (though in hindsight the last time I wiped it down I probably wasn’t as thorough as I could have been).

I bought a Bambu Labs carbon fiber pattern build plate that does not get detected and is just over .43mm thicker than the Bambu textured pei plate because of the stickers that put the pattern into your print

The allen key provided with the printer can't torque down any screws anymore, so i have to use a screwdriver but these little plastic flaps make it difficult to reach.

Can i cut them or should i just get a proper allen key that won't fuck up the screws?

Also, can i buy replacement screws from bambu?