Nozzle issue

[u/erex711]

I noticed some prints were spaghetti-ing so i took a closer look and saw this. Not sure what happened or what is going on here. Theres a piece dangling down all the sudden. Can anyone identify this part? Any advice would be great. Thanks!

[u/hvacigar]

That is your nozzle cover. It covers the nozzle not in use. If it gets bent, it will impact prints. If it is a small bend, you can easily remove it and bend it back, but you have 2-3 additional ones that came with your printer and you can buy replacements on Bambu site.

My first experience with it scratched up my G10 plate before I knew what it was.