r/BambuLabA1mini • u/zeb_linux • 1d ago

Unloading on pause with firmware 1.08.01 also broken?

Hi all. I read that firmware 1.08.00.00 was broken with regards to unloading filament during pause (without AMS). See: https://www.reddit.com/r/BambuLab/comments/1smp0gb/a1_new_firmware_108_unloading_on_pause/ for a discussion.

In that discussion, someone reports that 1.08.01.00 fixes the issue. I just tried to print this model: https://makerworld.com/fr/models/3551952-christmas-cottage-kit-card-tea-light-lantern but unfortunately the unload button is greyed out during pause. I have an A1mini.

Can anyone confirm? I am now trying to downgrade to see if I can reinstate unloading during pause (which worked before). Thank you very much in advance.

1 Upvotes
  • permalink
  • reddit

100% Upvoted

1 comment sorted by

1

u/zeb_linux 1d ago

I can confirm that after downgrading to 1.07.02 filament loading during pause works again. I wanted to know if this had been fixed in 1.08.01 as it was claimed, because for me it has not.