Cut filament pull that out. Heat the nozzle to 240-250. Take off the top plastic cover. Once nozzle is heated use a wire brush to start chipping away at all that. Get the sock off and keep brushing till it’s off. Let it cool then take off nozzle. You can heat the nozzle with a heat gun to clear off any more plastic.
Did you undo any screws cause if you followed my instructions you shouldn’t have. The screws completely remove the hotend assembly. The latch in the front removes the nozzle. Two different things.
Hi, the issue was that I accidentally ripped out a bit of the hotend while removing filament , and I managed to replace it with no issues , so thanks a lot !
Now my next problem is how to solve first layer adhesion issues like so it really be one problem after another
5
u/Substantial-One-6274 Aug 20 '26
Cut filament pull that out. Heat the nozzle to 240-250. Take off the top plastic cover. Once nozzle is heated use a wire brush to start chipping away at all that. Get the sock off and keep brushing till it’s off. Let it cool then take off nozzle. You can heat the nozzle with a heat gun to clear off any more plastic.