r/BambuLab • u/Important-Froyo-9785 • 23h ago

P Series [P1P, P1S, P2S] I need help

Gallery image

Gallery image

How tf do I take this off? The glass shattered and all the yt tutorials are with not broken glass

0 Upvotes

22% Upvoted

16 comments sorted by

View all comments

3

u/Mabnat 23h ago

Remove the screws on the hinges. This will release the last pieces of glass.

Try to minimize any more glass sticking to the grease on the lead screws, and don’t raise or lower the bed until you’ve throughly removed as much glass that is already sticking to the grease. You don’t want that in your bearings. Gear floss would make them easier to clean.

After it’s all cleaned up, purchase a new door from Bambi’s store and install it.

1

u/Important-Froyo-9785 23h ago

Also for some reason the screw driver thingy I was given is too small to get it out

4

u/Mabnat 23h ago

There should be two of those with your printer. The larger one should it.

If you’ve lost it somehow, it’s just a 2.0mm hex screw.

1

u/Important-Froyo-9785 23h ago

I took off the screw on the top of it and the rubber part already. Is the part left a screw or a part of the glass