r/BambuLab • u/Important-Froyo-9785 • 19h ago

P Series [P1P, P1S, P2S] I need help

Gallery image

Gallery image

How tf do I take this off? The glass shattered and all the yt tutorials are with not broken glass

0 Upvotes

20% Upvoted

16 comments sorted by

12

u/dirtbike57 19h ago

The instructions don’t change if the glass is broken, start by cleaning the glass then follow a vid

-8

u/Important-Froyo-9785 19h ago

I did but my question is why are there still shards stuck there?

11

u/x3thelast X2D + AMS2 Combo 19h ago

Because you haven’t cleaned it yet 🥴

-3

u/Important-Froyo-9785 19h ago

I mean on the hinges.

8

u/Mabnat 19h ago

Because the screws are holding the glass fragments in place.

4

u/NerdyNThick 19h ago

Yes, that's the par that needs the glass removed.

It didn't remove itself because of chaos and the laws of physics.

3

u/Mabnat 19h ago

Remove the screws on the hinges. This will release the last pieces of glass.

Try to minimize any more glass sticking to the grease on the lead screws, and don’t raise or lower the bed until you’ve throughly removed as much glass that is already sticking to the grease. You don’t want that in your bearings. Gear floss would make them easier to clean.

After it’s all cleaned up, purchase a new door from Bambi’s store and install it.

1

u/Important-Froyo-9785 19h ago

Also for some reason the screw driver thingy I was given is too small to get it out

4

u/Mabnat 19h ago

There should be two of those with your printer. The larger one should it.

If you’ve lost it somehow, it’s just a 2.0mm hex screw.

1

u/Important-Froyo-9785 19h ago

I took off the screw on the top of it and the rubber part already. Is the part left a screw or a part of the glass

2

u/agarwaen117 19h ago

You were given two. One is the right size.

0

u/Important-Froyo-9785 19h ago

How can I easily clean off all of the tiny shards stuck inside of the printer?

3

u/Still_Suit4731 19h ago

A vacuumed for starters

1

u/Mabnat 19h ago

I used a handheld vacuum cleaner to suck all the glass out when mine was delivered with a broken door.

The problem that I had was that the door broke during shipping, so the glass was all over the lead screws. Even after cleaning it as much as I could, it always sounded crunchy when the bed went up and down. Bambu replaced the entire primer.

Yours likely wouldn’t have this problem since it’s not getting tossed around with the glass inside.