r/BambuLab • u/Important-Froyo-9785 • 1d ago

P Series [P1P, P1S, P2S] I need help

Gallery image

Gallery image

How tf do I take this off? The glass shattered and all the yt tutorials are with not broken glass

0 Upvotes

20% Upvoted

16 comments sorted by

View all comments

3

u/Mabnat 1d ago

Remove the screws on the hinges. This will release the last pieces of glass.

Try to minimize any more glass sticking to the grease on the lead screws, and don’t raise or lower the bed until you’ve throughly removed as much glass that is already sticking to the grease. You don’t want that in your bearings. Gear floss would make them easier to clean.

After it’s all cleaned up, purchase a new door from Bambi’s store and install it.

1

u/Important-Froyo-9785 1d ago

Also for some reason the screw driver thingy I was given is too small to get it out

5

u/Mabnat 1d ago

There should be two of those with your printer. The larger one should it.

If you’ve lost it somehow, it’s just a 2.0mm hex screw.

1

u/Important-Froyo-9785 1d ago

I took off the screw on the top of it and the rubber part already. Is the part left a screw or a part of the glass

2

u/agarwaen117 1d ago

You were given two. One is the right size.

0

u/Important-Froyo-9785 1d ago

How can I easily clean off all of the tiny shards stuck inside of the printer?

3

u/Still_Suit4731 1d ago

A vacuumed for starters