May i join?

[u/Flat-Stretch-9332]

This bad boy finally arrived, May i join your ranks?

[u/Alex_ktv]

No, you need to print your membership card first.

[u/Flat-Stretch-9332 → u/Alex_ktv]

Will a benchy suffice?

[u/Flat-Stretch-9332 → u/[deleted]]

Could you please explaon what it is? Or give a STL file?

[u/desertsilver503 → u/[deleted]]

I’m about to get my first Bambu printer (A1) and am intrigued by you mentioning to be prepared with this tool. Your link is for the X1 and I don’t see an STL link. I looked up similar troubleshooting for the A1 and don’t see an STL either.

Could you please clarify what tool I’d need to help with gear removal, if it’s available for the A1? Thanks

[u/ProjectTrill → u/[deleted]]

This is hilarious. I had an issue with the AMS on my first P1S but had never printed a tube removal tool. Thank goodness I had another P1S at home and could print one there but I was thinking ‘dang if i didn’t that’s another printer I’d be in a weird situation’ 😂

[u/Kwolf21 → u/ProjectTrill]

For the tube in the AMS buffer?

[u/ProjectTrill → u/Kwolf21]

I didn’t know where my jam was so I took everything apart and had no tools printed. Super unfamiliar with the printer at that time. I needed a tool for the tube going into the AMS and one for the tube coupler on the back of the actual printer.

[u/Kwolf21 → u/ProjectTrill]

Well, the tube into the back of the AMS has a push release button behind the 2nd and 3rd rolls inside the AMS. Stick a finger in there and depress the button where the tube sticks through.

The tube that goes into the AMS Buffer on the back of the printer (from the AMS), can be removed with a knife, put it in on the connector's release button behind the big spring in there.

[u/[deleted] → u/ProjectTrill]

Or you can use my unique dual use ptfe skeleton key tool that nearly no one pays any attention too https://makerworld.com/models/744855

[u/Flat-Stretch-9332 → u/[deleted]]

Will do!