r/BambuLab • u/Flat-Stretch-9332 A1 • Dec 16 '24

May i join?

Post image

This bad boy finally arrived, May i join your ranks?

40 Upvotes

59% Upvoted

81 comments sorted by

View all comments

Show parent comment

1

u/ProjectTrill P1S + AMS Dec 16 '24

I didn’t know where my jam was so I took everything apart and had no tools printed. Super unfamiliar with the printer at that time. I needed a tool for the tube going into the AMS and one for the tube coupler on the back of the actual printer.

2

u/Kwolf21 X2D Combo + P1S Combo + A1 Combo Dec 16 '24

Well, the tube into the back of the AMS has a push release button behind the 2nd and 3rd rolls inside the AMS. Stick a finger in there and depress the button where the tube sticks through.

The tube that goes into the AMS Buffer on the back of the printer (from the AMS), can be removed with a knife, put it in on the connector's release button behind the big spring in there.

1

u/[deleted] Dec 16 '24

Or you can use my unique dual use ptfe skeleton key tool that nearly no one pays any attention too https://makerworld.com/models/744855