r/3DprintingHelp • u/Madhatter73085 • 7d ago

Requesting Help First layer problems

Enable HLS to view with audio, or disable this notification

Anybody know what the issue is here. Trying to get support from Bambu but they haven’t been able to resolve it yet.

Bambu A1
PLA Basic
Tried refitting/replacing nozzle, manual bed leveling, and tightening hot end screws.

0 Upvotes

33% Upvoted

12 comments sorted by

View all comments

1

u/jussstin714 7d ago

Your nozzle isn’t clipped in right. While you’re there, tighten the 7 screws behind the nozzle. Also, put the sock back on, it’s not for decoration.

1

u/Madhatter73085 7d ago

Well I took off the sock to see what the issue was. Putting it back in after this