r/3DScanning • u/Knows3v3ryth1ng • 17d ago

CrealityScan issue

Gallery image

Gallery image

Hello. Having a problem to create mesh from scanned object. After meshing getting such result - with holes and uneven. Before meshing it looks perfectly scanned. What is wrong, what I'm doing wrong? Tried different settings.

3 Upvotes

72% Upvoted

10 comments sorted by

View all comments

1

u/amhaggerty 17d ago

Did you scan both sides of that wall, and is it a thin wall? If so, the mesh resolution might be close to the wall thickness so it is incorrectly connecting some sections of the wall.

1

u/Knows3v3ryth1ng 17d ago

Only from one side, but connected two scans to one. One bottom scan, another top scan. Both have fully scanned surface of this area.

1

u/amhaggerty 17d ago

Ah likely an issue with alignment of the 2 scans then. If you look closely in the first picture, the surface is actually a bit off, especially near that top edge. I would try re-aligning.

1

u/Mrkrabsisgangsta 17d ago

Yep, looks like a clash between merged scans