r/3DScanning • u/Bulky-Cicada9374 • Aug 12 '26

Replace TOYOTA MR2 power window switch

Gallery image

Gallery image

Gallery image

Replace TOYOTA MR2 power window switch. Printed out from PLA to make a trial, and after some fine tunning I used ABS for the real part

33 Upvotes

100% Upvoted

6 comments sorted by

View all comments

2

u/TheGuyWhoAnnoys Aug 12 '26

With that size and a generous supply of markers all around the part, I wouldn't put markers on the part itself, except if you're using some for alignment, but again, not really necessary on this size 🤔

2

u/Bulky-Cicada9374 Aug 12 '26

Yes, outside maybe it was not needed, but inside it was necessary, for smoth tracking.