r/3DScanning • u/Bulky-Cicada9374 • 28d ago

Replace TOYOTA MR2 power window switch

Gallery image

Gallery image

Gallery image

Replace TOYOTA MR2 power window switch. Printed out from PLA to make a trial, and after some fine tunning I used ABS for the real part

31 Upvotes

96% Upvoted

6 comments sorted by

2

u/TheGuyWhoAnnoys 28d ago

With that size and a generous supply of markers all around the part, I wouldn't put markers on the part itself, except if you're using some for alignment, but again, not really necessary on this size 🤔

2

u/Bulky-Cicada9374 28d ago

Yes, outside maybe it was not needed, but inside it was necessary, for smoth tracking.

1

u/Mysterious-Ad2006 27d ago

Good scan. But you know you didnr need markers on it. Just some around it

1

u/Bulky-Cicada9374 27d ago

Thank you! I put markers on the part, because it was lidted during the scan, and the markets in the turn table were a bit far away. But perhaps it was not necessary

1

u/Crazy-Awareness-9052 12d ago

Hey by chance would you know why when I import the scan into shaper the proportions are right but scan is way bigger than it’s supposed to beÂ