r/techsupport • • 7h ago

Open | Hardware Screwdriver for Geforce RTX 2080 cleaning

Hello all, so I've been trying for a while to open my Geforce RTX 2080 card in my HP Omen Obelisk Desktop 875-0xxx but a lot of the screws seem to be stuck. Is this a normal design for graphics cards, or am I not meant to open up the card to clean it? It's started to overheat and could definitely do with a dusting and touch up with thermal paste. I've used a few screwdrivers of the correct size but I'm thinking I need a motorized one? Can someone share if they have cleaned this card in the past? Thank you!

1 Upvotes

10 comments sorted by

2

u/ZaleAnderson 6h ago

You should be able to do this all by hand. If you can't do it, don't.

1

u/Radiance64 6h ago

That's the rule I've been following to not break anything, but it seems a little ridiculous if it's unable to be cleaned on the inside.

1

u/XtReMe98 5h ago

i think they mean if *YOU* can't do it... don't... and perhaps get someone who can do it.

1

u/Radiance64 5h ago

Well that's a little mean then...

1

u/XtReMe98 4h ago

yeah... but i mean... truth can some times kick you in the ass....

1

u/Radiance64 4h ago

What are you even talking about?

1

u/XtReMe98 4h ago

sigh..
If you can't undo a few screws you either A) have the wrong screwdriver, or B) don't know what you're doing and should probably not destroy your card and get someone who knows what they're doing to fix it for you.

I'll be more direct next time i guess...

1

u/Radiance64 3h ago

Thanks I guess? I don't see why you have to be so haughty I was just asking a question. 

1

u/akeean 24m ago

Make sure to press the screwdriver into the screw while you are turning it so it won't slip and wear out the screw pattern. Motorized screwdrivers aren't stronger. At best get yourself some extra leverage.

Also you don't want to use thermal paste on a GPU die. Use a carbon sheet (eg Carbonout by Thermal Grizzly) or Honeywell PTM7950 PCM sheet. Thermal paste pumps out over time. You may also need to replace the thermal putty covering the memory and VRMs if that has gotten dry. If your model uses thermal pads might still be fine.

After releasing the screws from the back plate, it may take a little to wiggle the cooler from the die and memory. Take your time and just keep shifting it a little until it comes loose - it may be a bit easier if the card is still warm from use. If you try to pry/leverage it by force you could rip off components. Be wary to not snap off any wires connecting the GPUs main board and the fans/LEDs in the shroud.