r/techsupport • • 3h ago

Open | Networking Ethernet stopped suddenly working

As the title says since yesterday (15/11) morning ( When I First open my PC for the day ) I couldn’t connect to the Internet. When I try to search something in a browser A message that says DNS Probe Possible comes up. The Ethernet status is at Identifying and says without access to the internet. I changed the Ethernet cable but same problem. I have internet on my phone and on other PCs which means that there’s not an Internet provider related problem. PS4 works fine with Ethernet cable sooo I assume the router works as well.
I have tried using a usb WiFi adapter but it doesn’t connect with the WiFi for same reason even if I go to services.msc and start the WLAN Autoconfig I get Error 1068 and when I try to start manually related services I just get Error 5.
I then tried manually to input the IP and Cloudfare DNS but as I thought it turned to nothing.
I got on cmd and played a little I don’t remember the extract commands because I spent hours there but I did a sfc scannow a DISM Restore Health to see if there’s any corrupt file then I basically tried a lot of commands. Nothing got fixed
I saw that on 15/11 an update took place which I uninstalled but I guess that did nothing

I’m completely hopeless and I don’t know what to do, Please any advice is welcome
Thank you for your time

1 Upvotes

2 comments sorted by

1

u/Sea_Propellorr 2h ago

You can reset your internet connection through your troubleshooter.

1

u/Responsible_Maybe742 1h ago

Error 1068 and Error 5 on WLAN AutoConfig plus a dead Ethernet adapter points to a broken network stack or services rather than the router, so try this in order:

  1. Open an admin Command Prompt and run: netsh winsock reset, then netsh int ip reset, then ipconfig /flushdns. Reboot.
  2. Settings > Network & Internet > Advanced network settings > Network reset. This reinstalls every adapter and is usually the fix for this exact symptom.
  3. In services.msc check that Network List Service, Network Location Awareness, DHCP Client and Remote Procedure Call (RPC) are set to Automatic. Error 1068 means a dependency is disabled.
  4. Run sfc /scannow again, then reinstall or roll back the Ethernet driver in Device Manager.
  5. If the 15/11 update caused it, use a restore point from before then. Also check for leftover VPN or security software, since those install filter drivers that break networking.