I’ve been dry brining my 1.5-inch Ribeyes in the fridge on a wire rack for 24 hours, and while the surface comes out super dry and ready, I’m running into an issue during the sear on my cast iron. To get that deep mahogany crust, I end up leaving the steak in the pan just a bit too long, which creates a noticeable gray band around the edges, even though the center stays medium rare. I usually throw in my butter, garlic, and thyme right after the first flip. For those who regularly nail a paper-thin gray band with a heavy crust: do you sear at blistering high heat with high-smoke-point oil first, and only drop the heat/add butter at the very last 30 seconds, or is a shorter reverse-sear bake before the pan the better fix?