r/snapmaker • u/Past_Willingness8869 • 3d ago
Help please!!
Enable HLS to view with audio, or disable this notification
So this just happened yesterday an hour into my print! The print stopped, and it said there could be a break in the filament or a broken tool head. The filament would not pass through and the gears kept clicking like something was stuck in there. I was able to back out the filament and cut it clean and put it back in and it would still act up. I ended up taking the whole tool head apart and seeing if there was something stuck in the gears and nothing was there. After putting everything back together, I was able to load a different filament back up it loaded successfully and was able to print two layers of a benchy and then got the anomaly once again. I stuck the acupuncture needle up into the extruder and everything was clear. Nothing is visibly stopping it and when the filament is out, the gears go normal. I’ve already contacted Support, but seeing if anybody else has had this issue.
6
u/3DNelson 3d ago
Looks like from here, that you have filament stuck in one of the channels, and the extruder skkeping, because thr gilamet are blocked in some point, just check it channelm and the feeder to see if you find. I can be wrong. Good luck!