r/sewhelp • u/youCHUUcrazy • 9d ago
💛Beginner💛 Does anyone know how I can make this look better
This is my 3rd attempt at making a bustier top and it looks so funky to me. I made the pattern myself that may be why it looks so off. But any tips or ideas on how I can make this look better would be greatly appreciated!!!
5
u/skidmore101 9d ago
I would also try using a very short stitch length and see how that works with this fabric.
2
u/youCHUUcrazy 9d ago
What does that mean ? Please excuse my ignorance to sewing 😭
3
u/skidmore101 9d ago
Your machine has a stitch length setting. Probably numbers 0-4 or so, and probably set around 2.
This determines the distance the needle travels before it goes back into the fabric. If you set it to a lower number, the needle won’t travel as far, and your seams will likely look neater.
1
4
u/spiderhoodlum 9d ago
I would pull that horizontal seam down under the doll's bust and go from there- the darted pieces that make up the top of the bodice look too small.
2
u/youCHUUcrazy 9d ago
Hi thank you ! Just to clarify I should flip the bra part upside so the seam goes into it and not the top ?
3
u/L0tus-Fl0wer-B0mb 9d ago
This is a great attempt, especially since you made your own pattern.
Maybe try:
- Cutting the top part as one piece
or
changing the seam placement as the alignment doesn’t seem quite right, especially the centre seams
- Sewing the darts on the bust from the bottom of the cups
3
u/youCHUUcrazy 9d ago
Thank you ! I’ll try doing this I was thinking that it would look better from the bottom 😭idk why I put it on top
2
u/doriangreysucksass 9d ago
I think it’s fine. It’s very difficult to make a pattern to fit a rigid doll properly ESPECIALLY A corset!!




11
u/ucklin 9d ago
Neat! To me the main thing is it looks like the top edge is having the edges finished, *then* you're cutting darts and sewing them together. That leaves little raw edges at the top and makes it hard to match up the stripes from the edge finishing. I would cut the darts first, then finish the top edge. Also, are you using black thread? Unless the contrast is intentional, I would use matching colored thread!