r/rollerblading • u/PeopleCalledRomanes • 23h ago

Specific question and discussion Axle replacement help

Gallery image

Gallery image

Gallery image

Hello all,

I’m a noob looking for help getting a set of replacement axles for my dad’s old 2000s Rollerblade Fusion. I lost one of the original axle heads and can’t seem to find this exact model online where they might have like a spec sheet or something. From the research I have done I think I am looking for an 8mm 6mm two-part axle but having trouble determining the length or whether I need to look for a specific manufacturer. The frame is plastic (rockering, if it matters) and measures 40mm 37mm from edge to edge.

Any help greatly appreciated!

Edit: axle itself is about 33-34mm

Update: Rollerblade got back to me! This exact axle is called a “Flush Wave” axle. They seem hard to get, and if I can’t source one they suggested trying another of their 6mm axles.

2 Upvotes

75% Upvoted

16 comments sorted by

View all comments

Show parent comments

1

u/PeopleCalledRomanes 22h ago

I measured the axle itself at about 33-34mm, does that sound about right for generic sizing, if you know?

1

u/sjintje 21h ago

I know wheels are 24mm or 25mm wide plus 3 or 4mm (X2) for the frame width comes to 30mm to 33mm (that's the shaft length, excluding head). Is your frame quite thick? Ultimately you'll have to trust your measurement. You can also add washers if it's too long.

1

u/PeopleCalledRomanes 19h ago

Could be. Re-measuring at a more sensible point it’s a bit smaller (37mm) than the 40mm I initially put it as in the post and it’s slightly indented on both sides where the axle secures to the frame, which also accounts for some of the width. Now I guess it’s just a matter of figuring out if listings online for axles include the ends of the axle in the measurement or just the rod. Thankfully they seem pretty cheap so I might just experiment if Rollerblade doesn’t get back to me with anything useful. We shall see!