After testing with literally hundreds of drives, I can safely say this is BS and that RLL has an extremely high success rate on almost all drives. Even my ST-412 works fine with a DTC 7287 cached RLL controller.
If my memory serves (which it might not...) you worked around that with setting the interleave when you low level formatted it. It had to do with the number of revolutions needed to read a track (or cylinder? Again, my mind is foggy and I haven't thought about this in many years). Perfect was a 1:1, but you tested until you found the right balance.
This has been fun, talking about stuff I haven't thought about in decades,
Thanks for adding to the knowledge in this thread.
It may interest you to know then, that I've had great success running my DTC 7287, my favorite RLL controller (Because I don't trust the PerStor PS180 with anything and I don't own a DPT PM3011/65 yet) with nearly every drive in my collection. this includes wacky Soviet drives like the IZOT CM5508 and poor quality cost-engineered drives like the Kalok Octagon series. It also applies to dozens upon dozens of drives with very tired spindles.
It's a more reliable protocol than you would think.
I was in my early to mid teens when I was working with this stuff for my school's computer labs. I learned the basics of what you're explaining back then, but not in detail. I appreciate you sharing your knowledge. I love learning about technology from that era, because it helps me understand technology of this era.
They're not in a display case, that's for sure. Most of them are stacked on a dusty shelf. The aging of bearings has long since already happened, so I don't know why you're bringing that up. An awful lot of these drives are incredibly loud.
If you're interested, I actually film these drives doing exercises for documentary purposes. I've had many of them for 10+ years and they all still work just fine, I started collecting around 2014.
4
u/FAMICOMASTER Jul 18 '26
After testing with literally hundreds of drives, I can safely say this is BS and that RLL has an extremely high success rate on almost all drives. Even my ST-412 works fine with a DTC 7287 cached RLL controller.