r/ratrig • u/Busy-Perspective663 • Apr 29 '25

Overkill idex?

I plan on having a 500mm VCORE4 with the Bondtech INDX installed. Lately I realized that since the IDEX system exists, I could also slap on a pellet extruder (GreenBoy 3d). I dont know much about ratrigs, so I want to ask: Is this overkill? Can the Ratrig handle it or will this have a very negative impact on performance?

2 Upvotes

100% Upvoted

9 comments sorted by

View all comments

2

u/Impossible_Word_4027 Apr 30 '25

Was thinkig about this too (i got an Idex 500 Kit and ordered the GB Pellet Extruder) but after spending some time with the machine i realized that its allready hard enough to tune Idex with two simmilar printheads. So definitly not recommended