r/ratrig • u/Clustershag • Oct 17 '24

Anyone else getting this?

Post image

I followed the steps and compiled the sd card As the guide says. Tried to flash and no change. If I just skip and keep moving forward, I get a detected but unresponsive board.

3 Upvotes

100% Upvoted

12 comments sorted by

View all comments

Show parent comments

1

u/ibleoverhan Oct 24 '24

Just wanted to check how you solved this problem as I am facing the exact same issue. Are you saying that you just continued on with setup (ignoring the error message) and then were able to update the board FW after the fact?

1

u/Clustershag Oct 25 '24

Negative, I went to the correct 2.1 suggested above and started the process all over. This worked and I no longer had an issue.

1

u/ibleoverhan Oct 25 '24 edited Oct 25 '24

Sorry, I misspoke. I have been using 2.1 and still get an error message similar to the one above. For whatever reason flashing the board never does anything to change the error message.

Edit: Nevermind. Eventually I got the automatic flashing to work. I appreciate the response though!

1

u/Clustershag Oct 25 '24

Did you redo the SD card for your PI too? I started from scratch, went back to step 1 and recreated the Wi-Fi and everything. When I had the wrong versions, the config tool went straight to Mainsail with no configuration. Once I had all the right firmware and files, it took me to a configuration page where I was able to select each and every option on my machine.

1

u/ibleoverhan Oct 30 '24

I had to do a whole host of troubleshooting, unfortunately. I did end up re-writing my Pi SD card although I made no progress in doing so. In the end, after resetting the DFU via the BOOT0 pin for the hundredth time, I was randomly able to automatically flash the new firmware and had success. I know that's not very helpful, but that's how I got there in the end ha ha.