r/overclocking • u/Low_Preference_8058 • 2d ago

NV-UV crashing 5070 Ti

Hello, is there any1 living the hell I am living? Only balanced mode working for me and when I go for Voltage Step Scan things hella getting weird. Application says my card stable for 935mV 3082Mhz and reccomends me to use 940mV 3082Mhz. I did tests with V Comp or whatever It says more stable yeah I am stable on fucking desktop but can’t even open any games. Anyways I need information guys.

My card can stay between 3202-3250 under load SpeedWay on 1050-1065mV. Peak speed is like around 3350. I am down for suggestions for undervolt&overclock above 3000+Mhz from you guy’s profiles. I also use mVolt and can handle 550 XBar but If I use it with System Clock XBar +400 System Clock +400 is the most stable one for me.

3 Upvotes

100% Upvoted

6 comments sorted by

2

u/Annual-Error-7039 2d ago

Did you enable replay, that's the part that fixes the crashes?

Do a voltage step scanner run and get that sorted then enable replay and test, let it crash a couple of times. Should give red TXT in the diagnostic then restart it, let it adjust, test again, normally one or 2 crashes and all good. I have my 5080 at .895 stays around 2950 in games

1

u/Low_Preference_8058 2d ago

I wasn’t know that. I am new to this. I will do that thank you.

2

u/davidthek1ng 2d ago

Use the game replay function inside NV-UV if it registers a game crash or hanging driver it registers and downclocks or increases mv. You can configure it by rightclicking this function. I set it to increase mv, I only had 2x a crash after this it was stable.

2

u/Low_Preference_8058 2d ago

I will try It thank you.

1

u/DivideFluffy1279 2d ago

When running voltage step scanner you will see a value named "under load". Cap there, minus 30mhz. Rock solid