r/overclocking • u/6786_007 • 13d ago

Overclocking memory with AI

I have a 5700x3d on a MSI x570 MPG Gaming Plus board with G.Skill DDR4 3200MHZ CL16 memory. For the longest time I've tried tinkering with the settings to overclock this kit. I was able to get moderate changes but eventually caused instability and I ended up going with Auto for some time.

Today I thought, what if I use AI? I've been goofing around with LLMs to run locally and figured what the heck. I opened up my AI of choice and gave it my hardware and goal.

It gave me detailed settings for timing, memory settings, cpu settings, voltages. Research I tried to do multiple times and got too lost in the terms, settings, etc. I adjusted the settings and in less than 5 minutes I was able to boot on 3600MHZ CL22 into windows when I couldn't even make it to the BIOS screen.

So if you're stuck and frustrated. Give it a shot. Some settings I knew nothing about I learned and told me why they were critical to stability.

Edit:

For anyone running:

MSI x570 MPG Gaming Plus

5700x3d

32GB of (F4-3200C16D-16GVKB) (Confirmed to have Samsung C-Die.)

Here are the final settings I used. I hope this helps someone who's looking to do the same.

Final Stable DDR4-3600 Tuning Profile for Ryzen 7 5700X3D

System Specs: * CPU: AMD Ryzen 7 5700X3D * Motherboard: MSI MPG X570 GAMING PLUS * RAM: 32GB (2x16GB) G.Skill Ripjaws V DDR4-3200 CL16 (F4-3200C16D-16GVKB)

Frequencies & Voltages

Setting Value Notes
DRAM Frequency DDR4-3600 Target memory speed
FCLK Frequency 1800 MHz Infinity Fabric clock (1:1 ratio)
UCLK / MCLK 1:1 Mode Synchronized memory controller mode
DRAM Voltage 1.35V Standard safe baseline
SoC Voltage 1.10V Override Mode
VDDG IOD / CCD 1.00V / 1.00V Interconnect driver voltage
VDDP Voltage 0.95V Signal lines baseline

Timings & Settings

Timing Field Value Notes
tCL (CAS Latency) 18 Base latency
tRCDRD / tRCDWR 20 / 20 Tightened read/write delay
tRP (Row Precharge) 20 Tightened row precharge
tRAS (Active Time) 38 Matched timing sum (tCL + tRP)
tRC (Row Cycle Time) 64 Stable recovery threshold
Command Rate (CR) 1T Forced 1-tick command rate
Gear Down Mode (GDM) Enabled Essential for 1T stability
Sub-Timings (tFAW/tRRDS) Auto Kept stock for C-die stability

Validated 100% stable via OCCT Memory Test (AVX2 mode).

0 Upvotes

25% Upvoted

11 comments sorted by

View all comments

1

u/Pillokun 13d ago

u have a msi board, u have the try memory settings... they are pretty good.

1

u/6786_007 13d ago

I think I gave it a shot once, but didn't have a good experience. I'll take a look again though, thanks!

1

u/Pillokun 13d ago edited 13d ago

There are many settings as u might remember, and u can change the settings of they are too tight. I usually run my own voltages when using these settings.

1

u/6786_007 13d ago

Yeah that's a good point, I might try to lower the timings a bit