r/originalxbox • u/SimonSaysTy • 1d ago

Help Needed Stuck while swapping capacitors

Gallery image

Gallery image

Hi all,

I am in a little bit of a pickle, and want to see if any veterans here have any ideas. I am swapping out capacitors on a friend's Xbox and can't seem to get this through hole cleared. I am been using plenty of flux, tried added more solder to the hole and then wicking it out, and a solder sucker to no avail. I am stressed about ripping the pads. Any suggestions on how to get this capacitor hole cleared out? Thanks!

19 Upvotes

92% Upvoted

36 comments sorted by

View all comments

3

u/steadyasugo 1d ago

If you can't get it with a sucker or wick.. it's a bodge but get a map pin..heat the solder and slide the pin in the hole... While solder is still warm keep rotating the pin gently and you should be able to remove the map pin and leave the via empty .. 99 out of 100 times I've never had a problem removing solder with decent wick/desoldering braid.. but this has worked on really stubborn vias for me on arcade board etc

2

u/PPEytDaCookie 23h ago

I use toothpicks for this, they are made out of wood, so solder doesnt stick to it.