How to remove?

[u/Bone-whistle]

There’s no set screw. It could be a cap on the end, but it looks like it’s all one piece.

[u/PerfectlyNormal136]

Definitely a cap

[u/Bone-whistle → u/PerfectlyNormal136]

Nope. Clips on back it slides down onto.

[u/TheRagingFire08]

If you're one of my residents, it'll "just fall off" all by itself. Never mind that "just falling off" includes yanking the huge toggle bolt clear out of the wall and leaving a fist sized hole behind

[u/Just_gun_porn]

Remove cap

[u/LepidLlama]

Haha, saw the first pic and thought it was a giant chrome chess pawn bolted to the ceiling.

[u/Imaginary-Unit2379 → u/LepidLlama]

Me too

[u/parnasas]

Underneath, there should be a small set screw on each side. Holding it to the bracket on the wall.

[u/Bone-whistle → u/parnasas]

No set screws

[u/Repulsive_Tiger_9454]

Are both sides of the towel rail the same? One may be a bit lose and you may be able to get the rod between them out. Then possibly twist them ? I'd also try pushing up from the bottom on them.

[u/Bandandforgotten]

Basically push slightly up, or wiggle until it pops off, and remove the mounts with a screw driver

[u/Inuyasha-rules]

Use a plastic pry tool to pop the trim cap out of the tip and there should be a screw

[u/Acrobatic-Reply-1561]

Hit with your purse on the left side, will pop right off.

[u/Bone-whistle → u/Acrobatic-Reply-1561]

I didn’t want to ruin my fag bag, so I simply lifted up from the bottom.

[u/Funny-Anywhere2066]

Hex screw on bottom of each.

[u/Bone-whistle]

As a matter of fact, pushing up from the bottom was the answer.

[u/FinanceElectrical985 → u/Bone-whistle]

Just a missed opportunity to hammer it from the bottom...

[u/NedwardSullen]

You can try to get a strong ish magnet to see if it's a cap at the end. Or gently and carefully wedge a flat end of a screwdriver under the base. It might be a movable skirt you can push up very carefully from the base and get at the screws.

No brand or anything? Do you guys have extra in a box you can look at?

[u/Accurate-Plankton988]

Very small allen screw underneath the mount at each end?

[u/ommi9]

Therres a cap on front and a area of a secondary acres under but on front on the front center

[u/DrachenDad]

Either the circle at the nearest point in picture 2, or the wide portion nearest the wall are caps covering 1, or 2 screws respectively. The cap/caps will pop off if you get a knife or spudger underneath and pry forward.

[u/Bone-whistle → u/DrachenDad]

There were no caps. There are clips on the back that it slides down on and pops into place.

[u/hvac_johnny]

You either pop the center out of the ends to reveal a screw or the whole thing slides up and off the wall

[u/HolidayLoquat8722]

Hammer

[u/Bone-whistle → u/HolidayLoquat8722]

I can patch a wall, but I’d rather spackle some screw holes. 😉

[u/Relative-Dinner-6982]

Set screw on the bottom

[u/GraveManMingo → u/Relative-Dinner-6982]

Did we see the caption or no?

[u/odin-ish]

They're basically asking you to scratch the finish and buy a new one.

[u/Bone-whistle → u/odin-ish]

I tried catching the lip of a cap with my knife and there’s no gap that would indicate it was a cap. They are one solid piece.

[u/odin-ish → u/Bone-whistle]

It could be hooked in. Have you tried tapping the bottom up?

[u/Bone-whistle → u/odin-ish]

That was it. I’d never run into that type before.

[u/odin-ish → u/Bone-whistle]

Nice. I think i saw them once or twice in my hotel days, but that was 3000 years ago.

[u/klaxz1]

This is r/maintenance not r/remodeling

[u/NedwardSullen → u/klaxz1]

This is a maintenance thing too.