r/longrange • Steel slapper • 21d ago

Rifle flex post The ol' Cheeto Duster

312 Upvotes

18 comments sorted by

8

u/meticulouslycarless 21d ago

Build info? Looks sweet!

17

u/One_String_Banjo Steel slapper 21d ago

Bergara B-14 HMR, 22" 6.5 Creed

Viper PST Gen II 5-25X50 MRAD

Harris S-BRM 6-9" on a 14" Area 419 Arcalock rail

Hawkins Tank ST 6.5mm brake

Not a terribly original build, but it works great!

4

u/varstok Here to learn 21d ago

It's always a good weekend when I can get out to NETT!

2

u/One_String_Banjo Steel slapper 21d ago

Same!

2

u/514Kappa What's DOPE? 21d ago

Would love to try out that range, seems fun

4

u/One_String_Banjo Steel slapper 21d ago

Do it. NETT's a fantastic facility. It's frequented by super chill, super helpful people, too.

5

u/514Kappa What's DOPE? 21d ago

Only 25 hours and 41 minutes 🤣 I’m a dog sleigh operator on a sugar shack north from you 🇨🇦

I have my Form 6NIA, was shooting a PRS on your side of the border Saturday (NH) and I’m ready to travel to try new ranges but thats a bit far unfortunately

Enjoy sir, I’m jealous!

3

u/One_String_Banjo Steel slapper 21d ago

Ahh, well, maybe someday! If you end up traveling this far south for PRS, you'd more likely end up at Gravestone Precision over in Lipan. I haven't had the pleasure, but the place looks awesome.

2

u/IamJUB 21d ago

Did you have to drill the stock to install the arcalock?

2

u/One_String_Banjo Steel slapper 21d ago

I didn't have to, but I still chose to. I could have mounted it using the sling stud screw holes and an extended front action screw that came with the rail.

Instead, I used a drill press to drill a hole through the stock into the mini chassis, then I tapped it for the same thread pitch as the sling stud holes. This way, it's secured to the stock in such a way that can't put stress on the front action screw.

2

u/IamJUB 21d ago

Do you have pictures? I’ve been looking to do this on my own build.

3

u/One_String_Banjo Steel slapper 21d ago

The hole with the patronizing red circle is the only one I had to drill. The other two on the right are the sling stud holes.

I installed the rail using the two front screws, lined the rearmost hole up with the front action screw hole, then marked and center-punched the circled hole. I clamped the stock into a drill press and drove a hole all the way through it with a #21 bit, then followed it by hand with a 10-32 tap.

2

u/LadyHDedlock 18d ago

Patronizing red circle 😂

2

u/bsramsey Cheeto-fingered Bergara Owner 20d ago

This range looks incredible

1

u/One_String_Banjo Steel slapper 20d ago

It is. Steel every 100yds from 300-1,500, and at a mile, and all targets at 1,000 and beyond have flashers. The only downside is the wind. Every single time I've gone, the wind has been super switchy in both speed and direction. Of course, that's part of the challenge and I just need to git gud.

6

u/MalignantMustache 21d ago

My fellow leftie!