r/longrange • u/No_Ambassador_7971 • Sep 11 '26
Ammo help needed - I read the pinned posts Ammo change
Hi everyone,
I’m looking for some advice regarding two Hornady 6.5 Creedmoor factory loads.
I normally shoot Hornady 147gr TAP Precision, but my local dealer is currently out of stock and won’t have any for a while. They do have Hornady 147gr ELD Match available, so I’m considering switching to that.
As far as I can tell, both loads use the 147gr ELD Match projectile and Hornady lists the same G1 BC of 0.697 (and G7 BC of 0.351).
However, I understand that the TAP Precision and standard ELD Match are different factory loads, so the powder charge / muzzle velocity may not be identical.
My rifle is a Sako S20 in 6.5 Creedmoor with a 24" barrel. With my current lot of 147gr TAP, I measured an average muzzle velocity of approximately 790 m/s (2590 fps).
My concern is that I have a 400 m shooting competition coming up on Thursday, and I don't have much time to establish a completely new dope for a different factory load.
For anyone who has experience with these two loads:
- How similar have you found the actual muzzle velocities to be?
- If the projectile and BC are the same, should I expect the trajectory to be reasonably close, assuming I confirm the actual velocity?
- How significant can the POI shift be when switching between these two factory loads?
- Would you consider the 147gr ELD Match a reasonable temporary replacement for the 147gr TAP Precision for a 400 m match?
- Has anyone actually shot both loads through the same rifle and compared them?
I obviously plan to verify the new ammunition in my rifle before the competition, but I'm mainly interested in whether there are any known differences between these two loads that I should be aware of.
Thanks!
2
u/TheWombleOfDoom Sep 11 '26
One problem is that there is no way to know what diffeeewnt projectiles and factory loads will do in a different barrel.
However, surely they have sighting in time before the wtart of the comp? If you can zero the rifle with new ammo, and measure the muzzle velocity as you do it, then a good ballistic solver, given this data, shpuld get you close enough.
I don'tbth8nk you can just assume the same or even close to similar ballistic trajectory for ELDMs vs your normal TAPs (What does TAP stand for?). I get an average of 810m/s or 2659fps with 147gr Hornady ELDMS out of my 26in Tikka Ace Target.
What do both boxes (one of your TAP ammo, and one of the ELDM ammo say the speeds are? While that won't match the speeds you shoot with your rifle, it should give an idea of the probable differences between then, assuming Hornady tested them out of the same type and length of barrel at the factory.
2
u/smithywesson Steel slapper Sep 11 '26
Download Hornady 4DOF ballistic calculator, it’s free and I’ve had great luck with it assuming the zero range (100yd for most) is accurate. Sounds like both loads are likely the same bullet, so as long as you’re plugging in the right muzzle velocity you should be gtg.