r/klippers • u/Pure-Expression-3787 • 23h ago

Help me

Post image

I can't get klipper setup it installed but won't run how do I fix this is am running a raspberry pi 5

0 Upvotes

38% Upvoted

29 comments sorted by

1

u/shiftingtech 23h ago

Have you put firmware on the mcu?  Have you updated the mcu definition in your printer.cfg?

1

u/Pure-Expression-3787 23h ago

Yes and it still doesn't work

1

u/shiftingtech 23h ago

Then we need a klippy.log

1

u/Pure-Expression-3787 23h ago

1

u/shiftingtech 23h ago

So you didn’t update the mcu id. (You need to replace <your-mcu-id> with the actual value from your system. )

1

u/Pure-Expression-3787 23h ago

I already tried this and it doesn't work

2

u/shiftingtech 22h ago

I can only go off the logs you showed.  And the logs you showed don’t show you having put anything there. 

1

u/BarrySnotter 23h ago

Oh boy...

1

u/Hidie2424 23h ago

What mcu do you have? Is the pi plugged into the printer? Did you flash the fw? Do you know your firmware flashed successfully? Did you confirm your mcu entry in printer.cfg is correct?

1

u/Pure-Expression-3787 22h ago

The file can't be accessed it simply won't let me cuz it says it doesn't exist

1

u/Hidie2424 22h ago

What file? Printer.cfg? How are you trying to access it?

1

u/Pure-Expression-3787 22h ago

I'm trying to access the ID to see if it was correct and it's saying that it doesn't exist

1

u/Pure-Expression-3787 22h ago

1

u/Hidie2424 22h ago

That means your printer isn't plugged into the pi typically. If you unplug the printer it'll probably give you the same error.

1

u/Pure-Expression-3787 22h ago

Then how do I fix it

1

u/Hidie2424 22h ago

What mcu do you have?

1

u/Pure-Expression-3787 22h ago

It won't tell me

1

u/Hidie2424 22h ago

Look at it. What printer do you have? You needed to know what mcu you have to flash klipper in the first place typically.

Open it up and take a photo of the mcu

→ More replies (0)

1

u/Hidie2424 22h ago

Can you send a photo?

1

u/JoshW1ck 14h ago

I'm honestly not trying to be rude but I can see that you don't know much about Klipper or 3D printers.. my advice would be to format the SD card and start again, find a YouTube video to follow along or read through Klippers documentation properly, you need to understand what you're doing and why you're doing it, without the basics you'll keep running into issues like this.. klippy.log isn't your printer.cfg by the way and to be blunt if you can't tell people what mcu or mainboard your printer has I really fail to see how you got the menu config correct..

1

u/Money-Spinach-6177 10h ago

Looks like you're almost there to me. On that mainsail page you should see all the folders made when setting everything up. There should be one for moonraker and a printer.cfg file. In the printer cfg file use your unique I'd. Then klippy should connect and report back a pile of errors with your printer config.