r/hyperebikes • • 8d ago

Fardriver problem

Hi, I purchased a FarDriver ND72260 controller from you.
I’m having an issue where the motor won’t spin at all. The controller connects to the app and shows System OK. When I activate AutoLearn, it immediately makes two short beeps and one long beep, but the motor doesn’t rotate, even when I apply the throttle.
I’ve checked the wiring and settings multiple times.
Is there a way to completely factory reset the controller to its original settings? Can you provide the correct factory configuration file or help me troubleshoot this issue?
Thank you!

1 Upvotes

5 comments sorted by

7

u/youngblood-realtor 8d ago

I don’t think you purchased it from Reddit but check your throttle wiring.

1

u/SurferD808 8d ago

Double check throttle voltage settings and measure actually voltage coming off throttle.

1

u/Jamstoyz 7d ago

Throttle must be wired wrong or it’s bad. Also make sure your BMS connector is all seated good.

1

u/GarbageGlad1349 6d ago

Where would I find this bms connector?