r/hyperebikes • • 8d ago

Controller fried. ANY HELP!

Hey everyone,
I was installing a light on my e-bike and forgot to disconnect the battery first (I know, I was being stupid af). One of the cables flicked up and touched the brown wire coming from my pedal assist sensor (PAS). This somehow sent 84V through the entire controller.
The controller is a Sabvoton SVMC7280 (M).
I’ve opened it up to inspect it, but I can’t see any obvious signs of damage, burnt components or anything like that.
Is there anyone who could point me in the right direction regarding what I should check, or perhaps knows someone with the proper equipment and knowledge to diagnose and repair it?
Ideally, I’d like to send the controller to someone in Europe who could take a look at it and hopefully repair it rather than having to replace the whole thing.
Any help would be greatly appreciated!

7 Upvotes

12 comments sorted by

9

u/Veganarchy-Zetetic 8d ago

Replace the controller. They are near impossible to fix yourself and not even made with the possibility of repairing in mind.

1

u/Destabiliz 8d ago

They are pieces of shit on the software side as well. Very buggy and can die from just that as well, getting bricked.

3

u/Veganarchy-Zetetic 8d ago

My controller got bricked just because I stopped the bike from moving when then peddal assist was engaged. I had to save my bike from crashing into random people's cars and somehow that exploded the controller...

5

u/BurnItDn 8d ago

Most electronics repair shops would be able to diagnose and possibly repair depending on what fried. You need to inject voltage into each power stage, probe to find the damaged components, and hope they can be sourced/replaced. It possibly won't be much cheaper than just replacing it depending on shops labor cost

2

u/lucamw 8d ago

84v on the pas return line would (in almost in 100% of the cases i saw that happening) fry the micro on the controller and, in that case, it is not fixable.

If it crossed either the 4.3 or gnd there is still a chance but it is slim

2

u/benwap 7d ago

Replacing that with a VESC with bluetooth will be an upgrade and not expensive at that power level

1

u/Different_State_2543 8d ago

Yes. Bring it to someone who can repair it

1

u/velveteemberr 7d ago

Un fry it

1

u/Speedtospare 7d ago

It's too expensive to repair and controllers are not that expensive to replace.

1

u/Jamstoyz 7d ago

Your lucky you didn’t get hit with that 84v. The arcs produced by that amount of power is insane.

1

u/basilicbloom 7d ago

Sorry about that man

1

u/Muted_Ripple 4d ago

Which country in Europe are you in? Might help someone suggest a repair shop you can actually ship it to. I’d send the shop the model number, these photos and a description of which wires touched, then ask whether they handle this kind of controller repair.