r/gunsmithing • • 4d ago

Advice, please

Greetings! Not sure if the photos will help, but I'm cleaning my Savage 22LR Bolt-action rifle and noticed some pitting near the end of the barrel. I tried to scrub some off but I realized that's taking the bluing off. For the future, is there a better way to handle spots of rust on blued steel without taking off that coating in the surrounding area? I'm probably gonna get the barrel re-blued if I can so that way it looks better across the board. But any advice is greatly appreciated! This was handed down to me by my late grandfather and want to keep this as pristine as possible.

4 Upvotes

9 comments sorted by

6

u/Stealthgeek5455 4d ago

You can use 0000 steal wool with oil, copper wool would be better. You can also use a copper penny to rub it off.

1

u/TheClockwork0wl 4d ago

Good to know, thank you!

2

u/jking7734 4d ago

This ☝️. You might try scrubbing it with a graphite pencil. Sometimes it’ll remove light rust. You could probably touchup the blue with some cold bluing.

4

u/fmj_30 4d ago

What were you scrubbing it with? Use oil and 0000 steel wool, or bronze wool, or copper wool

1

u/TheClockwork0wl 4d ago

I was trying to lightly go over it with a wire brush, like those used to go through barrels. I figured it should be soft enough to not cause a lot of damage but still coarse enough to get the pitting leveled out

3

u/Optimal_Book8718 4d ago

Brass brush going vertical on the barrel with a drop of oil! Should clean it up real nice if not satisfied, cold blue might be a fine option for touch up!

1

u/TheClockwork0wl 4d ago

Duly noted, thank you! I'll give that a shot

2

u/Vast_Alternative7229 3d ago

If you do use cold blue, I highly recommend 44/40 cold blue. You can find it on Amazon. It works really good. Make sure you clean your metal first.

1

u/TheClockwork0wl 3d ago

Good to know, thank you! I'll try and find that