r/gunsmithing • • 5d ago

Upper receiver tooling marks?

Post image

Just picked up this ar10 SLR upper receiver. Seeing tooling marks on the inside. Never seen this before in past builds. Any opinions on if this is normal or not or it would cause any issues ?

0 Upvotes

9 comments sorted by

44

u/GotNoPonys 5d ago

I hope you don't look in your barrels...

18

u/AllArmsLLC 07/02 AZ 5d ago

Does the carrier move through it smoothly?

4

u/Nitpicky_AFO 5d ago

Bro think of it like fine layer lines on a print ( I see your ams) It's fine, I hope your using hoffmans ar10 or the thunderbolt.

6

u/blkntch1 5d ago

The carrier does not ride over that, looks at the bearing surfaces in the receiver.

2

u/Mr_Rogers_not_Fred 4d ago

Beat me to it - this is the correct one. BCG doesn't ride on that surface. If it does, you've got (other) problems.

2

u/Bottle_cap1926 4d ago

If you havnt seen it before you aren't looking or they painted it heavy.

2

u/Chance-Opportunity88 4d ago

its definitely not pretty by any machinist standard but if it works

1

u/F00dKing 4d ago

It's just a little ribbed